VISUAL QUICKPRO GUIDE PINNACLE LIQUID EDITION 6 FOR WINDOWS [Electronic resources] نسخه متنی

1.

Make sure the Logging Tool is closed, then in the Project Browser, if it is not already open, select the Rack that contains your logged clips.

2.

Right-click inside the right window of the Project Browser and select Batch Digitize from the pop-up menu.

3.

Select All In Rack (Figure 2.38 ).

4.

If there are clips in the Rack that have already been digitized, select Clips Not Yet Digitized.

The Logging Tool opens, displaying the batch digitizing interface and a list of all the clips you have logged, along with details on mark-in and mark-out points and the Reel name they were taken from (Figure 2.39 ).

The Audio and Media tabs have the same function here as they did when you were digitizing. See "Digitizing a DV tape" for details. The two options at the top are specialist options for batch digitizing. Details on this can be found in Chapter 8 of the Pinnacle Liquid Edition Reference manual.

5.

Check that you have the correct hard drive selected in the Media Management box and then click the Digitize button to begin the process.

6.

Confirm that you are using the right tape by clicking the check mark.

The Logging Tool rewinds the tape to just before the mark-in point of the first clip and then it starts to play (Figure 2.40 ).

When it reaches the mark-in point, it begins to digitize; when it reaches the mark-out point, it stops digitizing and fast forwards to the next mark-in point. This continues until all the clips have been digitized.

1.

Hold down the Ctrl key and then left-click each of the logged clips you are interested in.

2.

Click any of these clips and choose Selected from the Batch Digitize options (Figure 2.41 ).