VISUAL QUICKPRO GUIDE PINNACLE LIQUID EDITION 6 FOR WINDOWS [Electronic resources] نسخه متنی

Tool Buttons That Should Be Added to the Source Viewer

The Source Viewer is already fairly crowded, but you should add these four buttons to your interface if they are not already there. Chapter 1 contains complete details on how to add a button to any of the Liquid Edition interfaces.

:
Used to navigate both mark-in/mark-out points and also markers.
• 
  

  Open Marker List :
  Can be used to edit, rename, and navigate to markers.

• 
  

  Delete Marker :
  Used to delete the currently selected marker.

• 
  

  Play from Mark-In to Mark-Out :
  Used to play a clip from its mark-in to mark-out point rather than its clip-in to clip-out point.

Scrubbing a Media Clip

Scrubbing is a term used to describe the timeline cursor being moved manually through each frame rather than being played back. It's primarily used to find an exact position on the Timeline for either placing a special effect or inserting a new clip.

Scrubbing can be performed using either the mouse or the keyboard, or more likely, a combination of both.

You can scrub the Timeline using any of the following methods:

Trimming a clip in the Source Viewer




You can trim dynamically in the Timeline to adjust your clips the quick and dirty way. The more refined method is to use the Source Viewer to trim the clip. Once the clip is in the Source Viewer, your first job is to preview and look for anything that might need to be cut out from the start or the end. In fact, you might decide just to use a few seconds from the middle of the clip. You can do all of this by adding mark-in and mark-out points to the clip.

To add a mark-in or mark-out point in the Source Viewer





1.	Once the clip is loaded into the Source Viewer, use the mouse or the arrow keys to look for the best place for your clip to start. This is called scrubbing and is discussed earlier in this chapter.
2.	Once you have found the ideal place to start your clipthe mark-in pointpress the I key or click the Mark-In Point button . A small Mark-In Point icon has now been added to the Timeline of the Clip Viewer (Figure 6.47 ). Figure 6.47. A mark-in point added to the Source Viewer.
3.	To select a point where you would like your clip to finishthe mark-out pointscrub though the clip again until you find the optimal point; then press the O key or click the Mark-Out Point button . A small Mark-Out Point icon has now been added to the Timeline of the Clip Viewer (Figure 6.48 ). Figure 6.48. A mark-out point added to the Source Viewer.
4.	Use the Zoom tool to reduce the view if you can't see both the mark-in and the mark-out points on the Timeline display.
5.	Click the Play from Mark-In to Mark-Out button to play back the clip from the new points you have just defined.
6.	If the new mark-in and mark-out points don't suit your needs, you can set different points simply by moving the cursor to a new point and pressing the I or the O key again. Remember: adding either a mark-in or mark-out point does not physically alter the original clip. It merely tells the program to ignore any material that falls outside these two areas. For a further explication of nonlinear editing, see Chapter 1.




Tips

/ 244