Linux Unwired [Electronic resources] نسخه متنی

Chapter 8. Infrared

Infrared is a
legacy technology that won't die any time soon.
Sure, it has lousy range and can be a hassle to set up, but
sometimes, it's the only common communications
medium between your Linux box and something you want to talk to.

If you have ever used a remote control, you have used infrared
technology. Infrared is a wireless communication technology that
makes use of the invisible spectrum of light that is just beyond red
in the visible spectrum. It's suitable for
applications that require short-range, point-to-point data transfer.
Because it uses light, line of sight is a prerequisite for using
infrared. Despite this limitation, infrared is widely used in
household equipment and is increasingly popular in devices such as
digital cameras, PDAs, and notebook computers.

Founded in 1993 as a nonprofit organization, the
Infrared Data
Association (IrDA) is an international organization that creates and
promotes interoperable, low-cost infrared data interconnection
standards that allow users to transfer data from one device to
another. The Infrared Data Association standards support a broad
range of appliances, computing, and communications devices.

The term IrDA is typically used to refer to the protocols for infrared communications, not exclusively to the nonprofit body.

There are currently four versions of IrDA; their differences are
mainly in the transfer speed:

Serial Infrared (SIR)

The original standard with a transfer speed of up to 115 kbps

Medium Infrared (MIR)

Improved transfer speed of 1.152 Mbps; it is not widely implemented

Fast Infrared (FIR)

Speed of up to 4 Mbps; most new computers implement this standard

Very Fast Infrared (VFIR)

Speed of up to 16 Mbps; it is not widely implemented yet

When two devices with two different IrDA implementations
communicate, one steps down to the lower transfer speed.

In terms of operating range, infrared devices can communicate up to
one or two meters. Depending on the implementation, if a device uses
a lower power version, the range can be stepped down to a mere 20 to
30 cm. This is crucial for low-power devices.

A Cyclic Redundancy Check (CRC), which uses
a number derived from the transmitted data to verify its integrity,
protects all exchanged data packets. CRC-16 is used for speeds up to
1.152 Mbps, and CRC-32 is used for speeds up to 4 Mbps. The IrDA also
defines a bi-directional communication for infrared communications.

An infrared connection operates at a range of 0 to 1 meter, with peak
intensity within a 30-degree cone (see Figure 8-1).
With more power, a longer operating range is possible with a
reduction in transfer speed. In addition, an infrared connection
requires a visual line of sight in order to work, so there cannot be
any direct obstruction between the two communicating devices.

Figure 8-1. The 30-degree cone for peak power intensity of an infrared port

Setting up Infrared with
Linux can be tricky. Jean
Tourrilhes's
Linux-IrDA Quick Tutorial (http://www.hpl.hp.com/personal/Jean_Tourrilhes/IrDA/IrDAl)
lists 24 common pitfalls that await the unsuspecting user.

If your hardware supports SIR mode, this is usually straightforward.
FIR configuration is still somewhat arcane, unless you have a system
that's supported right out of the box. Most modern
notebooks support FIR by default, but you can often go into the BIOS
setup and change it to SIR. Even if you want FIR to work, be sure to
try SIR first, because it's usually the simplest.