1:
| On the core switch, configure the four VLANs that are shown, including their IP addressing. |
A1:
| The correct configuration is as follows:
core_sw(config)#interface vlan10
core_sw(config-if)#ip address 10.1.10.1 255.255.255.0
core_sw(config)#interface vlan11
core_sw(config-if)#ip address 10.1.11.1 255.255.255.0
core_sw(config)#interface vlan12
core_sw(config-if)#ip address 10.1.1.1 255.255.255.0
core_sw(config)#interface vlan20
core_sw(config-if)#ip address 10.1.20.1 255.255.255.0
|
2:
| Apply RFC 2827 filtering to VLAN10, VLAN11, and VLAN20. |
A2:
| The correct configuration is as follows:
core_sw(config)#access-list 110 permit ip 10.1.10.0 0.0.0.255 any
core_sw(config)#interface vlan10
core_sw(config-if)#ip access-group 110 in
core_sw(config)#access-list 111 permit ip 10.1.11.0 0.0.0.255 any
core_sw(config)#interface vlan11
core_sw(config-if)#ip access-group 111 in
core_sw(config)#access-list 120 permit ip 10.1.20.0 0.0.0.255 any
core_sw(config)#interface vlan20
core_sw(config-if)#ip access-group 120 in
|
لطفا منتظر باشید ...
